LATEST NEWS

  • VII Forum of machine-builders of Kazakhstan...

    06.09.2019

    On September 12-13, 2019 in Nur-Sultan, the VII EXPO Congress Center will be held at the E...

    More...
  • Meeting with the Company's team...

    04.09.2019

    On September 4, 2019, the executive secretary of the Ministry of Industry and Infrastructu...

    More...
  • Kazakhstan and Russia discussed the progress of im...

    28.08.2019 11:41:00

    On August 27, 2019, in Zhukovsky, the Minister of Industry and Infrastructure Development ...

    More...
More news

Обсуждены вопросы сотрудничества казахстанско-российских предприятий

ISSUES OF COOPERATION OF KAZAKHSTAN-RUSSIAN ENTERPRISES DISCUSSED

In the framework of the development of Kazakh-Russian cooperation, on August 14, 2019, in the city of Nur-Sultan, a meeting was held between the Chairman of the Management Board of JSC NC Kazakhstan Engineering Kuanysh Bishimov and the General Director of KAMAZ PJSC Sergey Kogogin. During the meeting, the Parties discussed the participation of PZTM JSC in the localization of the production of components for equipment of KAMAZ PJSC.

Recall that, at present, the investment project “Technological modernization of production of PZTM JSC is at the final stage. The main objective of the investment project is the acquisition of modern equipment from manufacturers such as DMG MORI, HYUNDAI (metal cutting, galvanic, thermal, welding, etc.).

The specified equipment will allow to produce products of higher quality at a relatively low cost, as well as master the production of components and parts of the KAMAZ automobile.

The meeting was also attended by the heads of subsidiaries of PZTM JSC Vadim Shakshakbaev and KAMAZ- Engineering JSC Sergey Kistin .

Following the meeting, the Parties agreed to consider the possibility of cooperation in this area, also during the negotiations KAMAZ PJSC expressed interest in the joint production of oil and gas equipment for the Russian market. In the near future, the specialists of KAMAZ PJSC will visit PZTM JSC to familiarize themselves with the production capabilities of the enterprise.

C Flattening: June 2, 2005 in Kokshetau was created the largest Kazakh-Russian joint venture to assemble trucks, dump trucks and special equipment on KAMAZ chassis - JSC "KAMAZ-Engineering". In the same year, the first production car rolled off the assembly line. All manufactured products are sold on the domestic market of the country. The quality and range of services provided by the enterprise to meet the needs of consumers is expanding. Today KAMAZ-Engineering JSC is one of the most technically equipped and modernized enterprises in Kazakhstan. In total, over 11,000 units of Kazakhstan assembly cars rolled off the assembly line.

Press Service of JSC "NC" Kazakhstan Engineering"

14.08.2019